Hi, all. I've been lurking for a few months -- I just graduated from the University of Washington's museum certification program in June -- but this is my first post.
And it is an utterly rookie newbie question. What is the best inexpensive way to cut foam core board? A brand-new exacto knife blade was not adequate to the purpose (the cut wasn't smooth no matter how hard I tried).
Thank you!
Meg Justus
budding freelance curation and exhibit person in the Tacoma, Washington, area -- M.M. (Meg) Justus on LinkedIn
=========================================================
Important Subscriber Information:
The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).
If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).