We are investing a significant amount of money into the fabrication of 
what I would consider are museum quality vitrines.

Can anyone share with me their preferred spec for glue/solvent?  we are 
looking having PS-30 used, because of the issue of bubbles in the seams.  
Other recommendations?

Do you use a spec, as you would in building, that clearly defines the 
parameters of what is acceptable?  For instance, in building a sheetrock 
wall, one might specifiy a variance of no more than 1/16" of an inch over 
16' feet, etc.

thanks.

jeff courtman

=========================================================
Important Subscriber Information:

The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).

If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).