Content-Transfer-Encoding: |
7bit |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Tue, 15 Jul 2003 23:33:32 EDT |
Content-Type: |
text/plain; charset="US-ASCII" |
MIME-Version: |
1.0 |
Reply-To: |
|
Parts/Attachments: |
|
|
I would suggest Ethafoam too - we use it extensively in conservation. It can
be easily shaped in profile on a bandsaw, rounded and contoured with rasp, and
details can be cut in with a hot knife/tool. It does have a rough, coarse
texture - that may be an issue for you. I would contact a company that
manufactures foam sheeting (Dow for example) and asked them for samples. Ethafoam is a
product name - it is actually closed cell polyethylene foam).
Here are a couple of distributors that I found off of the OSG-L disucssion
list (Objects Specialty Group of the AIC) there are probablyfoam suppliers
closer to you in California:
You can purchase ethafoam from: Republic Packaging
9160 S. Green Street
Chicago, Illinois
(312)233-6530
They sell 2lb. density planks (4' X 9') in a variety of thicknesses
including 1/2", 1", 2" and 4".
Ethafoam is available from United Foam, Georgetown, MA, 978-352-2200.
1" thick sheet is $34.50.
4# and 6# (harder) cost more. They have a $250 minimum. You can call them
to see if you can get it any thicker, in the past I have either hot glued
or hot melted 2" thick planks to get thicker pieces.
Cheers!
Dave
David Harvey
Artifacts
2930 South Birch Street
Denver, CO 80222
3093-300-5257
[log in to unmask]
=========================================================
Important Subscriber Information:
The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).
If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).
|
|
|