We use scalpels to cut our thin ethafoam, and cut on a large piece of plate
glass. We also create precise templates of the shapes we require(made out
of masonite). The results are highly satisfactory for the thin stock but
more difficult if you are working with very thick material.
ann molineux
At 03:16 AM 11/21/2002 -0500, you wrote:
>What is the best way to cut and shape ethafoam? Of course, I'm on a low
>budget and
>can't buy a $300 hot knife. Any suggestions will help. Thanks.
>Mickel Yantz
>
>=========================================================
>Important Subscriber Information:
>
>The Museum-L FAQ file is located at
>http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed
>information about the listserv commands by sending a one line e-mail
>message to [log in to unmask] . The body of the message should
>read "help" (without the quotes).
>
>If you decide to leave Museum-L, please send a one line e-mail message to
>[log in to unmask] . The body of the message should read
>"Signoff Museum-L" (without the quotes).
=========================================================
Important Subscriber Information:
The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).
If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).