Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Thu, 26 Jun 2003 08:31:19 -0400 |
Content-Transfer-Encoding: |
7bit |
Content-Type: |
text/plain; charset=us-ascii |
Reply-To: |
|
Parts/Attachments: |
|
|
I am putting a budget proposal together for an upcoming exhibit. I am stuck on one part and I'm not sure if its even answerable in this forum, but I thought I would check. What we are looking to have built are essentially either 3-dimensional or 2-dimensional cutouts of "characters" that would be placed outside. They would have to be out of a material that would withstand weathering. We most likely will have the designs done in house, so I am more looking for a ballpark figure of what the cost of production/fabrication would be. We would want several colors on each. They would be about 4 feet high and maybe 3 feet wide. I'm thinking probably 8-10 cutouts. I'm trying to think if there is any other information that would help. I know, this is such a general question but I am really looking for a general answer, i.e. probably not more than xxx amount but no less than xxx amount.
Thanks in advance for any information you might have.
Jennifer
=========================================================
Important Subscriber Information:
The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).
If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).
|
|
|