Subject: | |
From: | |
Reply To: | |
Date: | Thu, 21 Nov 2002 09:00:59 -0900 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
> What is the best way to cut and shape ethafoam? Of course, I'm on a low
budget and
> can't buy a $300 hot knife. Any suggestions will help. Thanks.
> Mickel Yantz
>
At some point in my travels my hot knife died, WAY out in the boonies, and
all I could find locally were a few different sizes of serrated, thin knives
at a local 2nd hand store. They work wonderfully. I also found that smooth
blades dull much faster so keep them "rough sharpened" by running a file
edgewise down the blade, producing many finer serrations. This technique
produces a faster cut with a more lasting edge. Cost of the blades and
file: less than $10.00. Thin blades can be bent into curves easily enough
and help carve out the pockets we sometimes need.
Granted this is not as smooth and elegant as a hot knife, but a quick
heating of the surface with a propane torch held at a distance will melt the
surface nicely, if you don't have a heat gun.
Best of luck
Tom Bennett
Exhibit Support, AK
=========================================================
Important Subscriber Information:
The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).
If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).
|
|
|