Subject: | |
From: | |
Reply To: | |
Date: | Wed, 12 Sep 2001 10:56:13 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I have found that applying tape to plexi along cut line reduces chipping, etc from saw. masking tape is fine.
Bill Low
"Palms, Anthony" wrote:
> I do archival framing on a regular basis. In most cases, using plexiglas or
> acrylic sheets as they are called. These acrylic sheets can be easily cut on
> a table saw using a composite blade. A regular crosscut blade would also
> work. But the cut may not be as smooth. Or you can score the material and
> snap it along the score mark. There is a scoring tool for this.
>
> The material is bonded using a solvent cement, something like Weld On #3,
> applied with a needle, not unlike medical syringe.
>
> If the edges are visible, they can be flame polished using a touch. First
> the sheets are run through the jointer to smooth the saw blade marks. You
> can also scrape it smooth with a razor or sand paper block.
>
> They sell plex cleaners. But mild soap and water with a soft rag works just
> as well.
>
> But a visit to the local plex supplier is recommended. AIN Plastics has
> branches nation wide 1-800-431-2451.
>
> Tony Palms
> USF Contemporary Art Museum
> > ----- Original Message -----
> > From: "Richard Barnes" <[log in to unmask]>
> > To: <[log in to unmask]>
> > Sent: Sunday, September 09, 2001 5:19 PM
> > Subject: Working with Plexiglass
> >
> >
> > > Hello, list-members. I'm fairly new to the list, although I have been
> > > "lurking" for a little while. My wife is the artist of the family and I
> > am
> > > the builder/carpenter. She has expressed a desire for some pieces to be
> > > framed behind Plexiglas, or perhaps to be encased in Plexiglas, similar
> > to
> > > displays that we have seen in museums. I am totally unfamiliar with the
> > > material, so I'll ask: Would anyone like to share their expertise or
> > point
> > > me to a resource where I could learn about working with this material?
> > > Specifically, I am looking for advice/knowledge on cutting,
> > > smoothing/polishing edges and techniques for bonding pieces together.
> > > Thanks in advance.
> >
>
> =========================================================
> Important Subscriber Information:
>
> The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).
>
> If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).
=========================================================
Important Subscriber Information:
The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).
If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).
|
|
|