Hey all, any one use a KeenCut Sabre General Purpose Board Cutter or any
other large cutter like that for cutting gatorboard?  If you have, did
you like it?  Is there one you'd recommend over another?

(This is a humongous flat cutter, like a matt cutter, that will cut 8'
pieces of gator or other very heavy board.)  Our standing cutter won't
allow us to cut on anything but a 90 degree angle.  Since we aren't
always that precise in our placements, we need more flexibility.

Thanks!

=========================================================
Important Subscriber Information:

The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).

If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).