Hi Deb,
Absolutely, wash and wax it before you place it outdoors, or at
least immediately after placing it outdoors. Even short term exposure to the
elements can have serious permanent effects on unprotected bronze.
First try to determine if it is already coated, and if so with
what. Colored waxes are sometimes used to tweak a patina in the factory, and
they can be unsettled by new coatings. Check to make sure your piece’s
coloring is an actual patina, and not colored wax by testing a small
unobtrusive area with the soap and wax you intend to use(below). If it seems
unstable or sensitive, then it should be left indoors until a conservator can
address the work. If stable, then on to washing.
Wash, never scrub no matter how dirty, with a soft
brush(ferrules padded with duct tape) and a mild detergent solution like Orvus
or Ivory. Rinse the brush often during the process. Wash from top to bottom. Rinse
the piece very well and allow it to air dry for several hours. Use a soft paper
towel(s) to blot off droplets and any pools on the work to speed the process.
Then apply a good wax coating(s). I use “Butcher’s
bowling alley wax” at the suggestion of our conservation team. It is easy
to apply and will dry clear and hard. Always use a different brush to apply the
wax than you used to wash the piece, although the same type of natural hair
brush should be used for both. The wax can be thinned with a little mineral
spirits depending upon your application technique. Two coats would be optimum
for a work that has never been coated before. You will get optimum results from
both washing and waxing if done on clear sunny days, where the work is warmed
by the sun.
There are a few waxes out there that can do the job, but Butcher’s
covers most of the bases well and can be easily acquired online. There are also
some newer experimental coatings, but they remain unconvincing. Do not use
automotive waxes on bronze.
Once cleaned, waxed, and dry, the work(s) can be lightly buffed with
a cotton cloth to bring out the shine then left outdoors(I assume it would
likely already be outdoors, but perhaps not). It is recommended that a new
coating be applied approximately every six months depending on the harshness of
your environment, with a minimum reapplication period of one year.
Please give me a call or e-mail if you want further direction or
advice.
Mark
Janzen
Registrar/Collections
Manager
Ulrich
Museum of Art
Martin
H. Bush Outdoor Sculpture Collection
316-978-5850
From: Museum discussion
list [mailto:[log in to unmask]] On Behalf Of Debra
Loguda-Summers
Sent: Wednesday, October 10, 2007 1:54 PM
To: [log in to unmask]
Subject: Statue
Hi everyone,
I think this may
have been an earlier discussion so I maybe repeating someone else.
We just received a
bronze statue to place in our Garden exhibit. We were wondering how to
clean and care for it. Is there anything we can do now since it is new to
help protect it better?
Thanks
Deb
Debra
Loguda-Summers, Curator
Still National Osteopathic Museum and National Center for Osteopathic History
800 West Jefferson
Kirksville, MO 63501
Phone: 660 626 2359
Fax: 660 626 2984
Toll Free: 1 866 626 ATSU Ext. 2359
[log in to unmask]
www.atsu.edu/museum
The Mission of the Still National Osteopathic
Museum is to collect, preserve, and make available artifacts and related
materials to communicate the history and philosophy about the osteopathic
principles of mind, body and spirit to a global audience
=========================================================
Important Subscriber Information:
The Museum-L FAQ file is located at
http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information
about the listserv commands by sending a one line e-mail message to
[log in to unmask] . The body of the message should read
"help" (without the quotes).
If you decide to leave Museum-L, please send a one line e-mail message to
[log in to unmask] . The body of the message should read
"Signoff Museum-L" (without the quotes).