I believe I owe credit for this one to the Nebraska State Museum exhibit staff.  The workshop (attached to a regional or national conference) suggested buying a long single slot toaster for heating the area of plexi you wanted to bend. 


>>> [log in to unmask] 04/26/02 03:59PM >>>
Hi,
I am looking for a source to purchase a plexiglass bender or directions for making a strip bender for use with plexiglass.  Can anyone help me out?  Lois

Lois J. Herr
Kansas State Historical Society
6425 SW Sixth Avenue
Topeka, KS 66615-1099
785.272.8681, ext. 251
Fax 785.272.8682
[log in to unmask]
www.kshs.org

=========================================================
Important Subscriber Information:

The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).

If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).
========================================================= Important Subscriber Information:

The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).

If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).