I agree with either using the Camger PolyGlaze or the Marvelseal. The best
thing to do is not use the plywood. Could you try Medite II instead?
--
Brent Ward
Riggs Ward Design
2805 Park Avenue
Richmond, Virginia 23221
804.254.1740  x207
[log in to unmask]
http://riggsward.com



> From: Les Reker <[log in to unmask]>
> Reply-To: Museum discussion list <[log in to unmask]>
> Date: Mon, 27 Oct 2003 15:28:50 -0500
> To: [log in to unmask]
> Subject: Re: off gassing from plywood
>
> Does anyone know the correct way to seal plywood to prevent "off-gassing"?
> It has been recommended that we use PolyGlaze 146, which is quiet expensive.
> Would anything else suffice? Would acrylic latex paint be acceptable or does
> it "off-gas" as well?
>
> Thank you
>
> LES REKER, Executive Director
> ART MUSEUM OF GREATER LAFAYETTE
> 102 South 10th Street,  Lafayette, IN 47905
>
>
>
>
>
>
>
> =========================================================
> Important Subscriber Information:
>
> The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/
> . You may obtain detailed information about the listserv commands by sending a
> one line e-mail message to [log in to unmask] . The body of the
> message should read "help" (without the quotes).
>
> If you decide to leave Museum-L, please send a one line e-mail message to
> [log in to unmask] . The body of the message should read "Signoff
> Museum-L" (without the quotes).

=========================================================
Important Subscriber Information:

The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).

If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).