Kirk-

As with most state run military museums, we're long on artifacts and short
on money and facilities.  We had a similar problem with over a hundred
aircraft and armored vehicle models in our collection.

We came up with a unique, and better yet, cheap solution.  We got a local
bakery to donate several rolling bread racks with the plastic trays.  They
are approximately 36x36 inches.  I can't imagine a B-36 model being any
larger than that.

We then placed foam core on the bottom of the trays and had the fabric shop
at our supporting Army National Guard Combined Support Maintenance Shop
(CSMS) make us some heavy olive drab canvas covers with heavy duty brass
zippers.  I'm sure being an Air National Guard museum; you have access to
the parachute riggers in your flying units who have the material and
equipment to make the covers.  If not go up to Camp Ripley and ask the Army
guys at your state's CSMS.

Does it meet AAM standards?  Probably not.  But is it practical for a museum
with little or no funds to buy the correct materiel, definitely yes!  The
beauty of this system is that it's self storing; you just roll the carts
around where you need them or where they take the least amount of space.


Daniel M. Sebby
Command Sergeant Major
California Center for Military History
California State Military Department

Historian and Webmaster
US Army Museum Activity, California
(California State Military Museum)

Preserving California's Military Heritage
www.militarymuseum.org
[log in to unmask]
-----Original Message-----
From: Museum discussion list [mailto:[log in to unmask]] On Behalf
Of Kirk Ransom
Sent: Monday, October 25, 2004 7:41 AM
To: [log in to unmask]
Subject: Placking and storing plastic models

Does anyone have experience and/or recommendations on packing plastic scale
airplane models for storage?

We have several hundred 1/72 and 1/48 or larger platic scale airplane models
we need to store away.  What kind of containers are used and how can they be
packed to prevent movements that would break small parts like landing gear
and propellers?

Often we receive these models in shoe boxes with tissue paper stuffed around
them.  This does not always prevent them from being tossed about and being
damaged.

Would it be a good idea to place each model in a plastic bag so if any small
parts are broken off, they can be kept together with the model?

I can envision using cardboard dividers to hold the wings and tail and small
styroform blocks to support the fuselage then more styroform blocks to fit
on top of the fuselage to be covered by cardboard or formboard covers.

What is a good source of boxes and containers for this project?

Kirk Ransom
Minnesota Air Guard Museum
Minneapolis St Paul Airport

=========================================================
Important Subscriber Information:

The Museum-L FAQ file is located at
http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed
information about the listserv commands by sending a one line e-mail message
to [log in to unmask] . The body of the message should read "help"
(without the quotes).

If you decide to leave Museum-L, please send a one line e-mail message to
[log in to unmask] . The body of the message should read "Signoff
Museum-L" (without the quotes).

=========================================================
Important Subscriber Information:

The Museum-L FAQ file is located at http://www.finalchapter.com/museum-l-faq/ . You may obtain detailed information about the listserv commands by sending a one line e-mail message to [log in to unmask] . The body of the message should read "help" (without the quotes).

If you decide to leave Museum-L, please send a one line e-mail message to [log in to unmask] . The body of the message should read "Signoff Museum-L" (without the quotes).